PLM setup
Each LPAR to be managed through PLM must be configured using the "plmsetup" command
Required parameters for the "plmsetup" command are:
Fully qualified host name of client LPAR
PLM user name, usually "root"
The "plmsetup" command requires "rsh" access to the client LPAR
"rsh" can be turned off after the initial setup
Test the PLM setup using the following command:
CT_CONTACT=<fullyQualifiedHostName> lsrsrc IBM.LPAR
If the above command returns information, the setup is correct
For assistance with designing, implementing, and supporting,
your automated CPU and Memory
allocation and deallocation using Partition Load Manager (PLM),
please contact Mt
Xia.
Slide ID:MXPLM-8